DocID026814 Rev 1 35/52
UM1811 ADP menu
52
Figure 23. Effect of show routing table command
7.5 ADP information base attributes description
Here is a brief description for all the attributes of the ADP information base.
Table 8. ADP G.9903 information base attributes52
Standard G.9903 ADP information base attributes
a d p S e c u r i t y L e v e l
The minimum security level to be used for incoming and outgoing adaptation
frames
a d p P r e f i x T a b l e
Contains the list of prefixes defined on this PAN. Note that it is assumed that the
link local IPv6 address exists independently and is not affected by the prefixes
defined in the prefix table
adpBroadcastLogTableEntryTTL Maximum time to live of a adpBroadcastLogTable entry (in seconds)
a d p M e t r i c T y p e A m e t r ic type to be used for routing purposes
adpNumDiscoveryAttempts
The number of discovery attempts
adpDiscoveryAttemptsWaitTime
Allows programming the maximum wait time between invocation of two
consecutive network discovery primitives (in seconds)
adpContextInformationTable
Contains the context information associated to each CID extension field
a d p C o o r d S h o r t A d d r e s s D e f i n e s the short address of the coordinator
a d p R L C E n a b l e d E n a b l e s the sending of RLCREQ frame by the device
a d p A d d R e v L i n k C o s t
It represents an additional cost to take into account a possible asymmetry in the
link
To Next Page
Loading...