ADP menu UM1811
36/52 DocID026814 Rev 1
a d p B r o a d c a s t L o g T a b l e C o n t a i ns the broadcast log table
a d p R o u t i n g T a b l e C o n t a i ns the routing table
adpUnicastRREQGenEnable
If TRUE, the RREQ shall be generated with its ''unicast RREQ'' flag set to '1'
If FALSE, the RREQ shall be generated with its ''unicast RREQ'' flag set to '0'
a d p G r o u p Ta b l e C o n t a i ns the group addresses to which the device belongs
a d p M a x H o p s D e f i n e s the maximum number of hops to be used by the routing algorithm
a d p D e v i c e T y p e
Defines the type of the device connected to the modem:
0: PAN device
1: PAN coordinator
2: not defined
a d p N e t T r a v e r s a l T i m e
Maximum time that a packet is expected to take to reach any node from any
node in seconds
adpRoutingTableEntryTTL Maximum time to live of a routing table entry (in seconds)
a d p K r A w e i g ht factor for the robust mode to calculate the link cost
a d p K m A w e i g ht factor for modulation to calculate the link cost
a d p K c A w e i g ht factor for the number of active tones to calculate the link cost
a d p K q A w e i g ht factor for LQI to calculate the route cost
a d p K h A w e i g ht factor for hop to calculate the link cost
a d p R R E Q R e t r i e s T h e n u mber of RREQ retransmission in case of RREP reception timeout
a d p R R E Q R E R R W a i t T i m e i n seconds to wait between two consecutive RREQ or RRER generations
a d p W e a k L Q I V a l u e
The weak link value defines the LQI value below which a link to a neighbor is
considered as a weak link. A value of 52 represents an SNR of 3 dB.
a d p K r t
A weight factor for the number of active routes in the routing table to calculate
the link cost
a d p S o f t V e r s i o n T h e s o ftware version
a d p S n i f f e r M o d e T h e S n iffer mode activation/deactivation
a d p B l a c k l i s t Ta b l e C o n t a i ns the list of the blacklisted neighbors
adpBlacklistTableEntryTTL
Maximum time to live of a blacklisted neighbor entry (in minutes)
a d p M a x J o i n W a i t T i m e N e t w o r k join timeout in seconds for LBD
a d p P a t h D i s c o v e r y T i m e T i m e o u t for path discovery in seconds
adpActiveKeyIndex Index of the active GMK to be used for data transmission
a d p D i s a b l e D e f a u l t R o u t i n g
If TRUE, the default routing (LOADng) is disabled. If FALSE, the default routing
(LOADng) is enabled
Table 8. ADP G.9903 information base attributes52 (continued)
Standard G.9903 ADP information base attributes
To Next Page
Loading...
