ST G3-PLC - Page 37

DocID026814 Rev 1 37/52
UM1811 ADP menu
52
Table 9. ADP ST implementation defined information base attributes
ST implementation defined attributes
adpDatagramTag
It defines the DatagramTag for the fragmentation dispatch. Increased by one for
each fragmented transmission.
adpBroadcastSeqNumber
It defines the SequenceNumber for the broadcast dispatch. Increased by one for
each broadcast transmission.
adpEnableHeaderCompression
If set to 1, it enables the IPv6 header compression (default), if set to 0, it disables
the IPv6 header compression.
adpRREQFfwdMaxTime
The maximum time in ms that can take a RREQ to be forwarded (512 ms by
default).
adpEAPPSKKey It contains the EAP-PSK used for bootstrap procedure.
adpEAPPSKIdP It contains the IdP (device NAI) attribute used for bootstrap.
adpEAPPSKIdPLen It contains the length of the IdP array used for bootstrap.
adpRREPWaitTime The time to wait before RREP generation (in order to collect other RREQs).
adpLOADngSeqNum The sequence number used by the LOADng routing algorithm.