Starcom Systems Helios - Page 114

Helios Users Guide
www.starcomgpsglobal.com 114

Location – the GPS location of the unit, including:
 Valid – the date and time of the last location transmission from the
unit
 Speed – the last recorded speed of the unit
 Mileage – the last recorded mileage of the unit
 Location – the GPS coordinates of the last position of the unit
 Heading – the vehicle moving direction
 Altitude – the last altitude of the unit
IO – unit input and output information
Commands
 Request Status – requests the current status of the unit
 Tracking – overrides the unit transmission rate settings and forces
the unit to transmit according to the specified interval.
 Stop Tracking – stops the tracking command and returns the unit to
its regular transmission rate
 Set Output – sends a command to the unit output: Siren On/Off,
Door Lock/Unlock, Gradual Stop On/Off, and Immobilizer Off.
 Voice Call – initiates a voice call with the unit
 Set Mileage – sets the specified mileage value in the unit
 Logic State – changes the unit logic state