Stiegelmeyer Deka - EMC Info Tables; Guidelines and Manufacturers Declaration

Appendix
EMC Info Tables
106
Instruction Manual
Please note: The information and test reports shown on the following pages refer partly to
electric and partly to mechanical beds Depending on the version of bed you have pur-
chased, refer to the appropriate information or fill in the appropriate inspection reports.
18.2 EMC Info Tables
To ensure EMC, only use cables and accessories approved by the manufacturer (see Available
Accessories » 105)
IMPORTANT
 The use of accessories, sensors or cables other than those approved, with the exception of
sensors and cables sold by the equipment manufacturer as replacement parts for internal
components, can result in an increase in the transmission level or a reduction in the immuni-
ty level of the equipment.
 The equipment may not be used directly next to or on top of other equipment.
 If it is necessary to use the equipment in this way, you must check to ensure that it functions
properly in the required configuration.
18.2.1 Guidelines and Manufacturer's Declaration
IMPORTANT
An electric bed from the Deka range is intended for use in the electromagnetic environment de-
scribed below. Operators of electric beds should ensure that the beds are used in such an envi-
ronment.
18.2.1.1 Electromagnetic Emissions
Interference Emission Meas-
urements
Compliance
Electromagnetic Environment
Guidelines
HF emissions
to CISPR 11
Group 1
The bed uses HF energy for its
internal functions only.
HF emissions
to CISPR 11
Class B
The bed is intended for use in all
types of establishment including
residential and similar uses that are
directly connected to a public sup-
ply network that also serves build-
ings used for residential purposes.
Harmonics
according to IEC 6100032
Class D
Voltage fluctuations/
/flicker acc. to IEC 6100033
Complies
HF emissions
to CISPR 141
Complies
The bed is not intended for connec-
tion to other technical equipment.