15.1.2 Fault Indicator (Version EM2 and EM3 Only)
For safety reasons, if a serious error is detected, the functions concerned are electronically locked
out. At the same time, the various errors are displayed on the handset and/or locking box by the
lock indicator flashing differently. This makes it easier to rectify faults.
Once the fault has been rectified, the control unit must be RESET to ensure that the system will
work properly again. The necessary steps are explained in the Chapter 15.1.3 Unlocking the Con-
trol Unit – Reset.
15.1.2.1 Handset with Magnetic Locking Function
If the bed is equipped with a handset with a magnetic locking function, the error codes will be
shown by the LEDs on the handset itself.
To Next Page
Loading...
