8.9 Double Traction Frame
Beds in the Deka range are fitted with adaptor sleeves for holding a double traction frame. A dou-
ble traction frame can be ordered at the customer’s request. The double traction frame is assem-
bled and fitted at the place of use. When a double traction frame is purchased, it is supplied with
an additional installation manual.
8.10 Decommissioning
If the bed is not used for an extended period, please follow the instructions below for taking the
bed out of service safely and ensuring ideal conditions for its re-use:
x Clean and disinfect the bed (see Cleaning and Disinfection » 73)
x Adjust the mattress base to a flat home position at its lowest level.
x For electric beds:
Lock the electric adjustment functions to prevent them from being activated accidentally or
by unauthorised persons
Charge the integrated battery (to do so, connect the bed to the mains electricity supply for
about 8 hours and then disconnect the mains plug from the socket.
Hang the mains cable on the headboard using the fixing clip attached to the mains cable
Repeat this procedure every 3 months to maintain the battery capacity
x Engage the brakes on the bed
x Pay attention to the ambient conditions required for storage (see Ambient Conditions » 34)
To Next Page
Loading...
