Stihl BR 800 - Removing the Clamp; Installing the Clamp; Removing the Throttle Cable; Installing the Throttle Cable

BR 800 43
N Push the handle (2 and 7) onto the post (arrow) of
clamp (17 and 18).
N Insert and tighten down the screws (8b) firmly.
15.4 Removing the Clamp
N Preparations, @ 3.1.
N Remove the control handle, @ 15.2.
N Take out the screw (14).
N Remove the locking lever (16) together with the pivot
pin (15).
N Pull the pivot pin (15) out of the locking lever (16).
N Separate clamp (18) from clamp (17) and take it off
the blower tube.
N Remove clamp (17).
15.5 Installing the Clamp
N Position clamp (17) against the blower tube.
N Position clamp (18) against the blower tube and hook
it to clamp (17).
N Insert pivot pin (15) in the locking lever (16).
N Place the locking lever (16) with pivot pin (15) in the
clamp (17) so that the holes in the pivot pin (15) and
clamp (17) line up.
N Insert and tighten down the screw (14).
N Install the control handle, @ 15.3.
15.6 Removing the Throttle Cable
N Preparations, @ 3.1.
N Remove the control handle, @ 15.2.
N Detach the sleeve (13).
N Pull the sleeve (13) off the throttle cable (12).
N Remove wiring harness from engine, @ 8.2.
N Disconnect throttle cable from carburetor, @ 8.2.
N Remove short circuit wire, ground wire and diagnostic
socket from the engine, @ 14.2.
15.7 Installing the Throttle Cable
N Fit short circuit wire, ground wire and diagnostic
socket on the engine, @ 14.3.
N Connect throttle cable to carburetor, @ 8.3.
N Install wiring harness on engine, @ 8.3.
N Push the sleeve (13) onto the throttle cable (12).
N Push the sleeve (13) into the retainer.
N Install the control handle, @ 15.3.