truck must also be powered down by removing
the battery plug.
Settings
When repairing or replacing hydraulic, elec-
tric or electronic components or assemblies,
always note the truck specific settings.
Hydraulic hoses
The hoses must be replaced every six years.
When replacing hydraulic components, also
replace the hoses in the hydraulic system.
Servicing and inspection
Thorough and expert servicing is one of the
most important requirements for the safe oper-
ation of the industrial truck. Failure to perform
regular servicing can lead to truck failure and
poses a potential hazard to personnel and
equipment.
The service intervals stated are based on
single shift operation under normal operating
conditions. They must be reduced according-
ly if the truck is to be used in conditions of
extreme dust, temperature fluctuations or mul-
tiple shifts.
The following maintenance checklist states the
tasks and intervals after which they should be
carried out. Maintenance intervals are defined
as:
●
Every 1000 operating hours, or at least ev-
ery six months.
●
Every 2000 operating hours, or at least an-
nually
In the run-in period - after approx. 100 service
hours - or after repair work, the owner must
check the wheel bolts and re-tighten if neces-
sary.
NOTE
Wheel bolts tightening torque please see sec-
tion: "Wheel bolts tightening torque".
Maintenance
5
Servicing and inspection
94 5091 801 1525EN-12/2022 - 06
To Next Page
Loading...