Drive operations
Instructions
Travel routes and work areas
Only use lanes and routes specifically desig-
nated for multi function vehicle traffic. Unau-
thorized third parties must stay away from
work areas. Loads must only be stored in pla-
ces specially designated for this purpose.
Driving conduct
The driver must adapt the travel speed to lo-
cal conditions. The multi function vehicle must
be driven at slow speed when negotiating
bends or narrow passageways, when passing
through swing doors and at blind spots. The
driver must always observe an adequate brak-
ing distance between the multi function vehicle
and the vehicle in front and must be in con-
trol of the multi function vehicle at all times.
Abrupt stopping (except in emergencies), rap-
id U turns and overtaking at dangerous or
blind spots are not permitted. It is forbidden
to lean out of or reach beyond the working and
operating area.
Nature of loads to be carried
The operator must make sure that the load
is in a satisfactory condition. Only carry loads
that are positioned safely and carefully. Use
suitable precautions, e.g. a load guard, to pre-
vent parts of the load from tipping or falling
down.
To prepare the multi function vehicle for operation
– Close the safety gates.
– Insert the key in the key switch and turn it to
the “ON” position .
– Pull up the emergency brake switch.
– Test horn.
– Check the operation of the brake.
WARNING
Before the multi function vehicle can be commis-
sioned, operated or a load unit lifted, the driver must
ensure that there is nobody within the hazardous
area.
Entry and exit
DANGER
Crushing by the operator platform safety gates.
There is a risk of hands or feet being crushed when
the safety gates are opened and closed.
CAUTION
Do not place any part of your body between the
safety gates and the frame of the operator platform
when opening the safety gates.
Operation
4
Drive operations
64 5091 801 1525EN-12/2022 - 06
To Next Page
Loading...