Still OCV 01 - Transporting the Truck

WARNING
Do not park the multi function vehicle on a slope. The
lift platform must always be lowered to the ground.
Transporting the truck
WARNING
Accidental movement during transport.
Improper fastening of the truck during transport can
result in serious accidents.
●
Loading must only be performed by spe-
cial personnel trained for this purpose. The
specialist personnel must be instructed in
securing loads on roads on road vehicles
and handling load securing devices. In each
case, correct measurements must be taken
and appropriate safety measures applied.
●
The truck must be correctly lashed down
when transported on a lorry or trailer.
●
The lorry or trailer must be equipped with
tie-down rings.
●
Secure the truck with chocks to prevent ac-
cidental movements.
●
Use only lashing straps with sufficient rated
strength.
●
Use non-slip materials to secure the trans-
port aids (pallet, wedges,....), e.g. non-slip-
mats
Determining the total actual weight
DANGER
Danger due to overloading of the means of trans-
port!
The load capacity/lifting capacity of the means of
transport, the ramps and the loading bridges must be
greater than the total actual weight of the industrial
truck. Components can be permanently deformed or
damaged due to overloading.
– Determine the total actual weight of the industrial
truck.
– Load the industrial truck only if the load capaci-
ty/lifting capacity of the means of transport, ramps
and loading bridges is greater than the total actual
weight of the industrial truck.
Before transport, the total actual weight of the
industrial truck must be determined:

Operation
4
Transporting the truck
 72 5091 801 1525EN-12/2022 - 06