Hydraulic fluid
WARNING
During operation of the truck, hydraulic
fluids are pressurised and are hazardous
to your health.
– Do not spill these fluids!
– Follow the statutory regulations
– Do not allow the fluids to come into
contact with hot motor parts.
– Do not allow to come into contact with
the skin.
– Avoid inhaling the spray
– Penetration of pressurised fluids into
the skin is particularly dangerous if
these fluids escape at high pressure
due to leaks in the hydraulic system.
In case of such injury, seek medical
advice immediately.
– To avoid injury, use appropriate per-
sonal protective equipment (e.g. pro-
tective gloves, industrial goggles, skin
protection and skin care products).
ENVIRONMENT NOTE
Hydraulic fluid is a water-polluting substance!
Always store hydraulic fluid in containers com-
plying with the regulations.
Avoid spilling.
Spilt hydraulic fluid should be removed with
oil-binding agents at once and disposed of ac-
cording to the regulations.
Dispose of old hydraulic fluid according to reg-
ulations.
Disposal of consumables
ENVIRONMENT NOTE
Materials that have to be disposed of follow-
ing maintenance, repair and cleaning must
be systematically collected and disposed of in
accordance with regulations. Observe the na-
tional regulations for your country. Work may
only be carried out in areas designated for
this purpose. Take care to minimise, as far as
possible, any impact on the environment.
●
Any spillage of fluids such as hydraulic oil,
brake fluid or gear lubricant oil must be
immediately soaked up with an oil-binding
agent.
●
The regulations for disposal of used oil are
applicable.
Safety regulations for operating mode drive
Routes and working areas
Only such lanes and routes that are specially
allocated for truck traffic may be used. Unau-
thorized third parties must stay away from the
working area. Loads may only be stored at
places specially provided for this purpose. The
truck must be only in work areas where there
is sufficient lighting, in order to avoid danger to
personnel and materals.
Driving the vehicle
The driver must choose a driving speed suit-
able for the local conditions. The truck must
be driven at slow speed on negotiating bends
or narrow passages, when passing through
swing doors and at blind spots. The driver
must always observe an adequate braking
distance between his truck and the vehicle
in front and he must be in control of his
truck at all times. Sudden stopping (except in
Safety
2
Safety regulations for operating mode drive
355091 801 1525EN-12/2022 - 06
To Next Page
Loading...