Wheels and tyres
DANGER
Risk to stability!
Failure to observe the following information and in-
structions can lead to a loss of stability. The truck
may tip over — risk of accident!
The following factors can lead to a loss of
stability and are therefore
prohibited
:
●
Wheels not approved by the manufacturer
●
Excessive wear to the tyres
●
Tyres of inferior quality
●
Changes to the wheel rims
●
Combination of wheels from different manu-
facturers
The following rules must be observed to en-
sure stability:
●
Only use wheels with equal and permitted
levels of wear to the tyres.
●
Only use tyres of the original tyre type.
●
Only use wheels approved by the manufac-
turer.
●
Only use high-quality products.
When changing wheels, always ensure that
this does not cause the truck to tilt to one side
(e.g. always replace right and left wheels at
the same time). Changes must only be made
following consultation with the manufacturer.
Wheels approved by the manufacturer can be
found on the spare parts list. If other wheels
are to be used, authorisation from the manu-
facturer must be obtained beforehand.
– Contact your authorised service centre re-
garding this matter.
Safety
2
Basic principles for safe operation
255091 801 1525EN-12/2022 - 06
To Next Page
Loading...