Still OCV 01 - Operating the Multi Function Vehicle Without Its Own Drive System

Operating the multi function
vehicle without its own drive
system
This operating mode is not permitted when
negotiating inclines and gradients. If the mul-
ti function vehicle has to be moved after a
failure has rendered it immobile, proceed as
follows:
– Set the emergency stop switch “OFF”.
– Set the key switch “OFF” and remove the
key.
– Prevent the truck from rolling away.
– Remove the cover.
– Connect wiring harness(1) to wiring har-
ness(2).
– Connect wiring harness(2) to positive and
negative pole of battery.
The brake is now released and the multi func-
tion vehicle can be pushed.
– Disconnect the harness(1) and harness(2).
The brake is now applied again.

Operation
4
Operating the multi function vehicle without its own drive system
 76 5091 801 1525EN-12/2022 - 06