Still OCV 01 - Picking up a Load; Transporting Loads; Parking the Multi Function Vehicle Securely

Picking up a load
– Open the safety gates.
– Go onto the operator platform.
– Close the safety gates.
– Turn the emergency stop switch to unlock it.
– Insert the key in the key switch and turn it to
the right. The truck is ready to operate.
– Drive the multi function vehicle carefully up
to the storage location(4).
– Press the "Lifting" button(1), lift the storage
table load handler reach the desired height.
– Pick the load to the storage table(3) on the
goods shelves.
CAUTION
Before a load can be placed, the driver must ensure
that the picking location is suitable for storing the
load (size and capacity).
WARNING
When the lift platform lifted, please try to avoid sud-
den steering and emergency stop operation.

Transporting loads
●
Always transport loads with storage table.
●
Gradually accelerate the vehicle.
●
Travel at a constant speed.
●
Always be prepared to brake. Only stop
suddenly in dangerous situations.
●
Reduce speed accordingly on narrow
bends.
CAUTION
Avoid placing the load down suddenly to avoid dam-
aging the load and the storage table.
Parking the multi function vehicle securely
When you leave the multi function vehicle it
must be securely parked even if you only in-
tend to leave it for a short time.
– Lower the load completely and position it
horizontally.
– Set the emergency brake switch “OFF”.
– Turn off the key switch and remove the key.
Operation
4
Picking up a load
 715091 801 1525EN-12/2022 - 06