Lithium battery appendix
Information on the conformity of
lithium-ion batteries
The manufacturer of the lithium-ion battery de-
clares that: the lithium-ion battery conforms
with the provisions of the following EU direc-
tive 2014/30/EU in accordance with EN12895.
These batteries has been certified according
to EN 62619:2017 for safe use and according
to UN38.3 for safe transport.
It is necessary to respect the following guidelines
– Read the documents provided with the bat-
tery carefully.
– Only persons who have been trained to
work with lithium-ion technology are permit-
ted to work on the batteries (for example
After-Sales Service Centre technicians).
– The truck can only be used with 135Ah bat-
teries.
– The batteries can only be used with Mobile
elevating work platforms.
– Do not drop it or allow anything to fall on it.
– Do not expose the battery unit to humidity
or water ( ＞ 80%).
– Protect the battery from solar irradiation.
– Do not physically machine or modify the
battery.
– Only trained and authorized personnel are
permitted to charge, service and replace the
batteries.
– Do not place lithium-ion batteries on or
near flames or hot heat sources (> 65°C).
This may cause the batteries to overheat or
burst into flames. This type of use also im-
pairs the performance of the batteries and
reduces their service life.
– It is forbidden to take out the battery in the
charging state.
– It is forbidden to use and store the battery
at low power (the use and storage of power
loss will cause the early loss of battery sys-
tem capacity and accelerate the service life
of the battery pack).
– It is forbidden for unqualified personnel to
dismantle and overhaul the battery system
and supporting charger and other devices;
the battery system is a dangerous product,
and maintenance and replacement can only
be performed by professionals.
– Before the vehicle is started, power on
through the button switch. After the vehi-
cle is stopped, the battery system must be
powered off and stopped through the button
switch, which can be judged by the state of
the display screen. If the time is too long,
the battery will be over-discharged. In se-
vere cases, it will affect the battery perform-
ance).
– The battery should be fully charged for the
first time.
– After each use, it should be charged in time
(the initial state of charging should keep the
battery system temperature below 40° C to
ensure the smoothness of charging).
– Do only use in trucks manufactured by sup-
plier and if the battery type is released for
that truck.
Operation
4
Lithium battery appendix
815091 801 1525EN-12/2022 - 06
To Next Page
Loading...