1. Type bin in the command prompt.
2. Type hash in the command prompt.
3. Type put xxx.tst [xxx could be any letters] to upload from the VSATs DVB interface.
Note, make sure this xxx.tst file already exists on the hub or workstation first before the test.
4. The same steps can be followed for uploading from the LAN interface.
D.3 Internal UDP Sender and Receiver for Testing the Satellite Link to the Hub
The internal UDP sender and receiver allows users to send and receive packets between the hub and
terminal. The internal UDP sender and receiver is used to check the transfer of packets between the hub
and terminal and to check whether there is any packet loss on the network.
The IP UDPSEND module generates UDP traffic with embedded packet identification so that, at the
receiver end, missing packets can be found by looking at the identification. This can be used to check the
link issues. UDPSEND can be configured to work in different ways; UDPSEND can pump traffic to a
single host, multiple hosts, or a range of hosts. UDPSEND can either continuously pump traffic until
explicitly stopped by the user or specified number of packets. The last used configurations will be stored
until re-configured explicitly.
To Next Page
Loading...