STM SatLink VSAT - Page 138

SatLink VSAT User Guide
Publication no. 101557
Rev 14.1.1-2
Copyright 2006-2012 – STM Group, Inc.
Page 137 (182)
3. Configure the UDP sender on the terminal as shown in the following example.
Example:
ip udpsend -taskstart
ip udpsend -conf -ip 10.10.10.25 -port 1111 -pps 100 -size 1400 -c 5000
4. In order to start sending packets to the port listener, type ip udpsend –start. This will start
sending the packets as shown below.
UDPSEND will be automatically stopped after counting the number of packets pumped, or
else you can stop the packet generator by using the stop command (i.e., you can stop the
task using the taskstop command).