Publication no. 101557
Rev 14.1.1-2
Copyright 2006-2012 – STM Group, Inc.
Check IP
connection with the
TFTP server.
The VSAT is not able to establish
connection with the TFTP server. Likely
to be an IP configuration or network
problem. Verify the IP connection with the
TFTP server by pinging.
Verify that the file
is present on the
TFTP server.
The VSAT is not able to upload the file
specified in the command from the TFTP
server. Verify that the file is available on
the TFTP server.
Check available
space on file
system.
The File transfer has been aborted either
due to an IP connection interruption
between the VSAT and the TFTP server or
due to a lack of available space on the
VSAT's file system.
Manual SW Upgraded
completed
It reports successful VSAT software
upgrade via TFTP.
Automatic SW
download started
The VSAT has started automatic
download via Multicast of a new software
version.
Automatic SW
download completed
The VSAT has successfully downloaded a
new software version via Multicast. The
VSAT will automatically restart and
activate the new software version.
Automatic SW
download failure
The VSAT failed to download a new
software version via Multicast. If the
problem persists after 20-60 minutes,
please contact the Hub operator.
TFTP download of new software image
failed.
Mcast SW download
started
The VSAT has started automatic
download via Multicast of a new software
version.
Mcast SW download
completed
The VSAT has successfully downloaded a
new software version via Multicast. The
VSAT will automatically restart and
activate the new software version.
The VSAT failed to download a new
software version via Multicast. If the
problem persists after 20-60 minutes,
please contact the Hub operator.
IP address conflict on
LAN
Check IP
configuration of the
VSAT.
The VSAT has detected conflicting IP
address on the LAN interface.
DNS server reply:
Recursion Not
Available
Change
configuration of
Hub DNS server to
allow reply
recursion.
DNS server does not allow reply
recursion.