Publication no. 101557
Rev 14.1.1-2
Copyright 2006-2012 – STM Group, Inc.
Check configuration
of the DNS primary
and secondary IP
address.
No connectivity with DNS server.
The VSAT IP address of the LAN or DVB
interface is changed. New IP address is
visible in the log.
The VSAT network mask of the LAN or
DVB interface is changed. The new
network mask is visible in the log.
A virtual interface is created.
A virtual interface is deleted.
A new IP route is configured in the VSAT.
The VSAT configuration is saved.
No Global NAT Addr
defined
Add global NAT
address to the
VSAT
configuration.
The VSAT NAT functionality is enabled
but no global NAT address is defined.
VSAT IP cannot be
used as Global NAT
Addr
Check NAT
configuration of the
VSAT.
The VSAT does not allow using the DVB
address as global NAT address.
The VSAT has added a web site in the
HTTPA bypass list.
Events for Mesh capable only SatLink VSAT
The VSAT has successfully logged on to
the Mesh Controller.
DLCP logon Failure:
Unauthorized Logon
If the problem
persists, contact
your hub operator.
The VSAT's logon was to the Mesh
Network was refused. Contact your Hub
operator. The VSAT DVB and LAN IP
address and subnet must fall into the mesh
network address space to get authorized to
logon.
DLCP link
establishment success
The VSAT has established a new dynamic
connection.
If the problem
persists, contact
your hub operator.
The mesh controller
might be out of
service.
The VSAT was not able to establish a new
dynamic connection.
DLCP link service tear
down timeout
A dynamic connection is closed due to
timeout. Timeout occurs when no packets
are received in any direction for a certain
amount of time configured by the Hub
operator.
DLCP link service tear
down last link service
The VSAT is closing the last dynamic
connection.
DLCP link service tear
down
A dynamic connection is closed either
from the VSAT or the Mesh Controller.
To Next Page
Loading...