Stonex S10A GNSS Receiver – User Manual 17
Changing the working mode and data link
When Stonex S10A is switched on, press F key and very quickly the Power
key, if the speaker is enabled S10A broadcasts “change working” and all the
leds start to blink at the same time. Then release both keys.
Change working mode:
Every time F key is pressed, S10A broadcasts “static”, “rover” or “base”, and
the related Led is blinking (static led blinking in the first case and GSM and
radio led blinking at the same time in the case of “rover” or “base”). Confirm
the desired option by pressing power key.
Change data link:
After confirming the working mode, receiver will broadcast: “Change data
link” and GSM, RADIO and power key start blinking at the same time.
Every time F key is pressed, S10A broadcasts “Radio”, “network” or “external”
and the corresponding led blinks, user can confirm the data link desired by
pressing power key once.
After confirming the working mode, receiver will broadcast “set Wi-Fi” if
speaker is enable and Wi-Fi and power led will blink ad the same time. By
pressing F key, user can enable or disable Wi-Fi, after choosing the option
confirm by pressing power key.
Self-Check: it is a procedure predisposed for verifying the correct working
of the instrument device. The program is mainly to predict whether the
receiver modules work normal ahead of time or not. S10A self-checking part
includes GPS, WIFI, Bluetooth, radio, network and sensor; a total of six parts.
- When the receiver is on, long press and hold I key until you are
prompted turn off the device and release it, then long press I key again.
You will hear the beep to voice broadcast self-check and release it, then
the receiver carry out self-check including GPS module, UHF module,
and GPRS module.
- Self-check lasts typically around 1 minute. In the process of self-check,
if you have failure in one module, and the voice broadcast the module
does not work normal, this module led will continue to beep, until the
user restart the receiver. If you have found it, please contact Stonex.
To Next Page
Loading...
Need help?
General
