Stonex S10A GNSS Receiver – User Manual 20
5. STONEX® Web UI Applications
Users can manage S10A through a web interface called WebUI, it is not
necessary to install software, drivers or other kinds of programs; the web
interface program is built inside the receiver. From WebUI, users can set the
most common operations such as working mode, UHF connection, GPRS
connection, etc.
These functions can be set from a PC, a smartphone or a tablet, it is only
necessary a Wi-fi hardware and a web browser. Following, the principal ways
to establish the connection.
5.1. How to connect to WebUI
1. The first step is to check if Wi-Fi network is available; it must be on.
Search the S10A network using the connection management of the device.
You can identify it by the serial number of the instrument. Then select it as
the figure 5.1 shows:
Figure 5.1
Once connected you have to open the browser and enter the Ip Address:
http://192.168.10.1. After sending enter, you will be required to enter user
and password. S10A default user and password are:
User: admin
Password: password
To Next Page
Loading...
Need help?
General
