STONEX S10A - Frequently Asked Questions (FAQ)

Stonex S10A GNSS Receiver – User Manual 45
Appendix 3: Frequently Asked Questions
1. The receiver is set in static mode but it does not save data even if more
than three satellites are locked. The three red lights are blinking.
Solution: the internal memory of receiver is full, some files must be deleted.
2. The external and built-in power lights are blinking but no corrections is
received.
Solution: The activation code of the GPS expired; please contact STONEX®
for a new code.
3. No success connecting the controller and the GPS via Bluetooth.
Solution: the receiver has a different working mode with respect to the
menu of the controller, switch the mode. If the problem persists, contact
STONEX®.
4. The receiver is set in rover mode and GPRS/GSM data link, the SIM card is
placed in its slot under the battery. However, no chances to read in the SIM
card.
Solution: Every SIM has its PIN number, it must be disabled. Moreover,
check on a cell phone that there is enough credit on the SIM for connecting
to the internet.
5. The base is transmitting a radio signal, the rover is set in rover mode and
built-in radio data link, but data link light is turned off and rover does not
receiver correction:
The radio channels are different from Base to Rover, use the controller to
select the correct radio channel on the rover.
It is also important to point out that in each weather condition after coming
back from the field you should keep the receiver in a warm and dry place
and at the same time take out the controller and receiver from the case, in
order to make them dry. Anyway, we recommend you to manage the
instrument with reasonable care.