Strong SRT 7015 - Single Satellite Search

20
satellite, sat position is 1. The version of SatCR is either 1.0 or 2.0. Version 1.0 can have up to 8 dierent users,
version 2.0 can have up to 32, it depends on the LNB and splitter used. SatCR systems are usually installed by
professional experts. An optional satellite splitter is required for multi-users.
For SatCR use, DiSEqC and polarity should be disabled.
If a SatCR LNB is used, please refer to the manual of that LNB to obtain the technical data about User Bands
numbers and corresponding frequencies.
NOTE: SatCR can only work in combination with an optional multi-output satellite splitter and a SatCR
LNB, example STRONG type SRT L780 (max. 4 users). Note: SatCR cannot be combined with any
other DiSEqC function. SatCR systems are mainly installed by professional experts.
IF Channel Manual select: Select the User band ID number according to the specications of
your SatCR LNB. NOTE: Any SatCR LNB user in the chain needs a dierent Channel ID
number.
Centre Freq Manual select: Select the Centre Frequency according to the specications of your
SatCR LNB, corresponding with the correct IF Channel. NOTE: Any SatCR LNB user in
the chain needs a dierent Centre Frequency.
Sat Position Select the number assigned to the satellite by the installer. If you only use only one
SatCR LNB, (for one satellite) then the number is 1.
Version The version of SatCR is either 1.0 or 2.0. Version 1.0 can have up to 8 dierent users,
version 2.0 can have up to 32, it depends on the LNB and signal splitter used.
Select SAVE to store the settings.
7.1.4 Single satellite search
To search just one satellite, selected before in the Satellite List.
Satellite: Select a satellite with tu to be scanned. You may have selected more than one
satellite in the satellite list.
FTA Only: Press tu to select No to search for scrambled and free channels or Yes to search for
Free to Air channels only.
NOTE: Scrambled channels can not be watched with this receiver.
Scan Channel: Press tu to select TV+Radio, TV Channel or Radio
Scan Mode: Use tu to select mode auto scan, pre-set scan or accurate Scan.
This the default mode and should be used rst.
Auto Scan All stored transponders in the memory will be scanned.
Pre-set Scan A few satellites carry a list with transponder parameters of all transponders on that
satellite. It can be useful if the auto scan does not nd an expected channel.
Accurate scan This is a blind scan mode, in which the scan process probes certain frequencies to
nd unknow parameters of a Satellite.
Network Search Use tu to select Yes or No. Some providers use more than one transponder to
transmit their Pay-TV programmes. Select Yes and one of those transponders and
it will nd the corresponding transponders as well. Note: This is only applicable for
scrambled channels, which can not be seen with this receiver.
Tuner Not applicable for this receiver.
After conguring, select Search and press OK to start scanning with the selected settings.
Your receiver will now perform an (automatic) channel search with the scanning progress shown on screen.
During the channel search you can quit the scan process with . When the process has been completed, all
found channels will be stored. Press OK to conrm and leave the menu by pressing with  several times, or
proceed to editing parameters by pressing  only once.
Multi-Satellites Search:
To scan more than one satellite in one go.