26
4:3 Letterbox 4:3LB (Letterbox)
For 4:3 TV screens. The unit will display all content in its original aspect ratio. Programmes formatted in 16:9
will be presented with black bars on the top and bottom.
4:3 Pan&Scan 4:3PS (Pan&Scan)
For 4:3 TV screens.16:9 content will have the extreme left and right portions cut o and presented full
screen.
Digital Audio Output Select digital audio output mode. Settings aect both S/PDIF and HDMI
outputs.
PCM – audio from any format will be converted to PCM Stereo format
RAW – audio from receiver will be send out in the original format
Using PCM mode is the best option if you do not have a TV or Digital Amplier that are not able to process
Multi audio.
7.3.5 Local Time Setting
Press MENU and select Local Time Setting The menu provides options to adjust the time and date settings.
Press pq to select an option and tu to adjust the setting. Press to exit the menu.
Region Select the region or country in which you live. This will set the time oset from
UTC automatically.
UTC Usage Select By Region (the Region selection is valid), User Dene (You may select your
UTC Oset yourself) or O (Time and Date setting are free to adapt.) However,
the default By Region setting and the correct Region setting are usually
sucient. In case the Daylight Saving Time should not be delivered by the
broadcaster, you can adapt it here.
UTC Oset : Select the correct Time Zone in which you live.
Summer Time You may adapt On or O for Daylight Saving Time, should it not be delivered by
the broadcaster.
Date: Enter the date when UTC Usage is set to O.
Time: Enter the time when UTC Usage is set to {O.
7.3.5.1 Timer Setting
In this menu you can setup the schedule for automatic switching to the dened channels at a particular
date/time.
Timers can be set directly from the EPG window or manually from this screen. Not set timers will be default
O
To enter a new timer manually, select an O marked timer in the list and press OK.
Timer Mode Select Once for a onetime event, select Daily for each day, same time event. A
free timer is default O.
Timer Service Select Channel to wake up the receiver to view the channel.
Wakeup Channel Select the channel for this event. Use tu or OK for a pull down list to select.
Wakeup Date Select the date for the event.
On Time Enter the time to start the event.
Duration Enter the length of the event.
After all settings have been made, select Save to store the settings. Select Cancel to discard the settings.
To edit an already existing timer entry, select the entry in the list and press OK, then select and edit the item
which you wish to change.
To delete an already existing timer entry, select the entry in the list and press OK, then select and set Timer
Mode to O and select Save to store.
Exit the screens with .
To Next Page
Loading...
Need help?
General
Weight and Dimensions
