19
Limit Setup To setup the limits the dish should not exceed when moving, in case of physical
obstructions. Default is disable limit (not active). If needed, the motor can physically
be brought to its 0° reference position, to align the dish south when in the northern
hemisphere (or north for southern hemisphere) rst.
To set the West Limit, use tu to select West Limit, then press shortly t to move the
dish West. Press t again or OK when the limit is reached.
Press OK again. A pop-up message will conrm: West Limit is set.
To set the East Limit, use tu to select East Limit, then press shortly u to move the
dish East. Press u again or OK when the limit is reached. Press OK again. A pop-up
message will conrm: East Limit is set.
To disable the limits, select disable limit, then limit setup and press OK. A pop-up message will conrm:
disable limit is set.
When all settings have been made, press to save the data and leave the window.
GotoX
(also known as DiSEqC 1.3 or USALS)
GotoX is an automated system for nding satellites with a motor driven dish. It is an enhancement of the
DiSEqC 1.2 protocol, where it was still needed to manually search and store every satellite individually. With
DiSEqC 1.3 every satellite position is automatically calculated for a dened geographical location on earth.
Only this location is needed to be entered and stored in to the box, in conjunction with a GotoX capable
motor drive, all (pre-installed) satellites can easily be found. The dish/motor-combination itself needs to be
aligned due South (North for Southern hemisphere) at its reference position at 0°. Refer to the manual of
your motor-drive for more detailed information.
LNB Frequency Select the correct LNB which is placed in your Satellite Dish.
Motor Type Select GotoX with the tu buttons.
Local Longitude Find out the coordinates of the location where the dish is installed. Consisting of
degrees on northern or southern hemisphere and eastern or western hemisphere.
When you rst enter, choose E or W with the tu buttons.
Then use the 0 ~ 9 buttons to enter the coordinate.
Local Latitude When you rst enter, choose N or S with the tu buttons.
Then use the 0 ~ 9 buttons to enter the coordinate.
NOTE: The location setting only needs to be entered once and is valid for all satellites.
Delete All Turns the entered Longitude and Latitude to 0.00
Motor Setting To make a test with the moving dish if the selected satellites in the satellite list
indeed can be found.
Limit Setup To setup the limits the dish should not exceed when moving, in case of physical
obstructions. Default is disable limit (not active). If needed, the motor can physically
be brought to its 0° reference position, to align the dish South when in the northern
hemisphere (or north for southern hemisphere) rst.
To set the West Limit, use tu to select West Limit, then press shortly t to move the
dish West. Press t again or OK when the limit is reached.
Press OK again. A pop-up message will conrm: West limit is set.
To set the East Limit, use tu to select East Limit, then press shortly u to move the
dish East. Press u again or OK when the limit is reached.
Press OK again. A pop-up message will conrm: East Limit is set.
To disable the limits, select Disable Limit, then Limit Setup and press OK. A pop-up message will conrm:
Disable Limit is set.
When all settings have been made, press to save the data and leave the window.
7.1.3 SatCR
SatCR LNB's are used for SatCR systems, mainly in apartment blocks. Enter the IF channel number according
the assigned (user band), then the corresponding Centre Frequency. If the system only supports one
To Next Page
Loading...
Need help?
General
Weight and Dimensions
