7
1.4 Accessories
1x installation instructions
1x Safety and guarantee instructions
1x remote control
2x batteries (AAA type)
NOTE: The batteries should not be recharged, disassembled, electrically short-circuited or be mixed or
used with other types of batteries. If rechargeable accumulators instead of batteries are going to be
used, we recommend using (e.g. NiMH) types with low self-discharge to ensure long time operation
of remote control.
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
specications, multimedia, functions of the receiver might not work properly.*
If you are going to use an external USB HDD (Hard Disk Drive), please consider that the power
specications may exceed the supported output of your receiver (5 V/800 mA). If so, please connect your
USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
It is advised not to store important information on USB storage devices used with the receiver. Always
make backups of data on your USB storage device before using it with this receiver. STRONG will not take
responsibility for any loss of information or circumstances caused by loss of information.
STRONG cannot guarantee the playback of all les although extensions are listed, as it depends on le
size, codec, bit rate and resolution.
Please ensure that either the USB device is already formatted to FAT/FAT32.
2. YOUR RECEIVER
2.1 PIN code default: 0000
2.2 Front and side panel
Fig.1
1. LED display: Shows channel number in operation and time in Standby
2. Standby indicator: Shows power state of the receiver: RED LED - receiver is in standby mode
3. IR Sensor: Receives commands from the remote control
4. Power button: Switch the receiver to Standby or On.
5. USB: For connection of USB device for Multimedia use
USB 5V
500 mA max.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
