Strong SRT 8119 User Manual

English
The picture and sound
remain frozen, or macro
blocks or similar distortion
are visible on the screen.
The transmission signals are
too weak or have reections/
interference.
The antenna is not properly
adjusted.
Press the INFO key on the remote
control 3x to call up signal bars to
visually assess signal strength and
signal quality (both parameters
should be visible in the last third
of the infobars). Contact your local
Service.
No sound on TV or
amplier.
The volume of the TV is set
too low.
The volume of the receiver is
set too low.
Increase the volume of the TV with
its remote control.
Increase the volume of the receiver
with its remote control.
The correct input is not
selected on your TV or
amplier, or the unit is set
to a higher resolution than
supported by the TV.
Switch to the correct TV/amplier
input.
Select lower resolution on the
receiver.
The TV, digital receiver or
amplier is not switched on.
Switch the TV/digital receiver/
amplier on.
The TV or digital receiver is
not connected to the mains.
Check the mains lead.
Bad cable connection.
Make sure that any existing digital
or analogue A/V cable connections
between the used equipment (TV,
digital receiver, or A/V amplier) are
properly connected.
Audio is muted.
Press the ! button on your remote
control.
The TV power is o. Turn the TV on.
No access to scrambled
services.
The channel is scrambled.
Your receiver does not
support scrambled channels.
Select an alternative channel.
19

Strong SRT 8119 Specifications

General

Aspect ratio	4:3, 16:9
Signal source	Terrestrial
Video resolutions	720 x 576, 1280 x 720, 1920 x 1080 pixels
Supported video modes	576i, 576p, 720p, 1080i, 1080p
Analog signal format system	NTSC, PAL, VHF
Digital signal format system	DVB-T2
High Dynamic Range (HDR) supported	Yes
Personal Video Recorder (PVR) included	-
Tuner type	Analog & digital
Demodulation	16-QAM, 64-QAM, 128-QAM, 256-QAM, COFDM
Product color	Black
Audio decoders	Dolby Digital Plus
Number of tuners	- tuner(s)
Audio output channels	- channels
Audio formats supported	AC3, MPEG-1, MPEG-2
Video formats supported	H.264, HEVC/H.265, MPEG4-ASP
Flash memory	4 MB
Internal memory	64 MB
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
AC input voltage	100 - 240 V
AC input frequency	50/60 Hz
Power consumption (standby)	1 W
Power consumption (typical)	4 W
Storage temperature (T-T)	-10 - 50 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	91.1 mm
Width	145 mm
Height	35.5 mm
Weight	145 g