61
7
ENTRETIENSTÛV 21
.5 COMPONENTS REPLACEMENT
121110
987
T20
PH2
ou
Step 7 Find the side of the frame that has
2 perforated flat sections, these need to
be facing up towards the philips screw
ports
Step 8 Slide the new seal onto the
underwire make sure they are of equal
length on both sides, leaving more
clearance on the horizontal part.
Step 9 Insert the 2 frame extremities into
the 2 orifices at the bottom of the door
making sure the flat sections are facing
up, insert the seal into the groove of the
door.
Step 10 Slightly lift the door (45°) and
slide up the glass 4’’ secure the frame by
piercing the seal with the screw, do not
tighten too much so the seal doesn’t lift at
all angles. Hand tighten is perfect.
Step 11 Make sure the screws went
through the frame orifice by lightly
squeezing the seal.
Step 12 Adjust the seal by stretching the
extremities to the edge of the glass. Fold
the pointed flap onto the seal by using a
flathead screwdriver. Make sure the point
enters well into the seal.
Proceed to reassemble (explained at
the end of the chapter)
To Next Page
Loading...
