STW TC1 - Signal Daemon

7 Teleservice Application Framework
User Manual 109/374
7.2.8 Signal daemon
Daemon location
Configuration file
/usr/local/bin/ysignald
/etc/init.d/ysignald.config
How to activate the configuration file of the signal daemon
Activate the configuration file of the signal daemon, so the signal daemon is started during the boot up
sequence automatically.
1. Rename the configuration file of the ysignald the following way:
# mv /etc/init.d/_ysignald.config /etc/init.d/ysignald.config
2. Reboot the system
# reboot
ysignald
The signal daemon signalizes the current status of the module over led signal.
NOTE:
The signal daemon can only be used, when a LED is available.