STW TC1 - Target Group; Used Symbols and Formats

3 General Information
User Manual 16/374
3.5 Target Group
This manual describes the handling and characteristics of the TC1. It is designed to be a comprehensive
source of information about the TC1 for system design, engineering and maintenance personnel.
System development, installation and commissioning of the TC1 must only be carried out by trained and
experienced personnel who are sufficiently familiar with the used components and with the complete system.
To be able to understand and use the TC1 this personnel must be familiar with:
 The programming language C and shell scripting
 Installation and usage of communication interfaces like CAN bus, RS232, ETH, WIFI, GSM, GPS and BT
 STW offers training courses for commissioning and programming the TC1. Please see the training catalog
of our Academy on the homepage of STW:www.sensor-technik.de (http://www.sensor-technik.de/)
3.6 Used Symbols and Formats
The following symbols and formats are used in our manuals to mark important information:
WARNING:
Warning on faults and errors during the application development.
NOTE:
A note provides additional and important information of the system behavior.
RECOMMENDATION:
A recommendation provides recommended actions that can provide an easier live.
REQUIREMENT:
A requirement is the law, stick to it otherwise you are in big trouble.