STW TC1 - Page 198

7 Teleservice Application Framework
User Manual 198/374
Structure T_DBUS_Util
typedef struct
{
DBusConnection* pt_dbus_conn; // D-BUS connection instance
charn acn_myNameString[128]; // Name of the application, Don't use any
special
// characters, white spaces or new lines!
charn acn_myVersion[128]; // Additional value (for HELLO) signal (opt.)
charn acn_myStatus[128]; // Additional value (for HELLO) signal (opt.)
charn acn_myAddInfo[512]; // Additional value (for HELLO) signal (opt.)
sint32 s32_myTriginterval; // Time interval when the ysysd
// expects to be triggered
charn acn_myCMDOnWatchdog[2048]; // Bash cmd that must be executed
// by the ysysd in case no
// trigger signal occurred in time.
} T_DBUS_Util;
Output Information
Return Value
Description
C_NO_ERR
Function executed without error
event condition was successfully set
C_COM
D-Bus communication error
C_UNKNOWN_ERR
NULL pointer error or wrong parameters
C_NOACT
Error occurs because:
 log job name invalid
 log job does not exist
 log job active, variable does not exist in data pool
 cannot update log job
C_RANGE
Parameters are out of range
7.3.6.2.4 ylogd_set_log_mechanism
Function Description
sint32 ylogd_set_log_mechanism (const T_DBUS_Util *const opt_DBusInstance, const charn *
const opcn_LogJobName, const uint8 ou8_LogMechanism)
The function sets the log mechanism for the selected logger specified in name opcn_LogJobName.
NOTE:
For an illustration of the logging sequence see How the logger mechanism works (see "Introduction"
on page 189).