7 Teleservice Application Framework
User Manual 99/374
# If no interval is set, the interval of the watchdog will be set to the default time
interval of 10s.
watchdog_interval 10
# System reboot path, max. path length 255. After the time interval has elapsed without
triggering the watchdog,
# the ysysd would kill the ysmsd and execute the "CMDOnWatchdog" command.
# If no path is set, the default (signal01.beep) will be set.
CMDOnWatchdog /sbin/reboot
Section: Fetch SMS interval
# The time interval for to send and for to and receive SMS messages is scaled in seconds.
# Min. interval and default 60s, max. interval 0x7FFFFFF, recommended max. 180s
# If the interval is less than 60s, the default will be set and an error message will be
put on stdout.
default_sms_fetch_interval 180
Section: Number of failed network registrations
# If the verification of the GSM network registration status was not successful after
NoNetRegCounter times, then the SMS daemon will restart the modem.
# Min. count index 1, max. count index 0x7FFFFFF, recommended max. is 240.
# If count index is less than 1, default will be set to 3 and an error message will be put
on stdout.
NoNetRegCounter 240
Section: GSM status interval
# The SMS daemon supervises the needed GSM status periodically. Every
"verify_gsm_status_interval" seconds.
# Min. interval and default is 120s, max. interval is 0x7FFFFFFF, recommended max. is 1000s
# If the interval is less than 120s, the default will be set and an error message will be
put on stdout.
verify_gsm_status_interval 120
Section: SMS user space interface
# The virtual port of the GSM modem is reserved for SMS functionality.
# Max. path length 255
# If no path is set, an error message will be put on stdout. The daemon will not be
started!
gsm_tty_path /dev/mux1
Section: Modem restart command
# This section defines the path of the restart script.
# If the modem is no longer accessible, then make sure to restart the modem.
# Max. path length 255
# If no path is set, an error message will be put on stdout. The daemon will not be
started!
modem_restart_script /etc/init.d/scripts/gsm restart
Section: SMS outgoing folder
# In case the system shuts down before all SMS are put to the outgoing folder, all outgoing
SMS are saved to this file.
# This file will be loaded at the next system start.
# Max. path length 255
# If no path is set, an error message will be put on stdout. The daemon will not be
To Next Page
Loading...
Need help?
General