SubGear XP-3G - Setting Dual Depth Alarm; Setting Incremental Depth Alarm

94
Settings
Adjusting the display contrast
1. Confirm that you wish to adjust the display contrast by pushing .
The current setting starts to flash.
2. Set the contrast by pushing or .
Low contrast: (1), high contrast: (12)
3. Confirm the setting with .
Selecting the IrDA speed
The default setting is low. For faster downloads you can set it to high, but not all IrDA interfaces are
compatible with high.
1. Confirm that you wish to change the IrDA speed by pushing . “Lo” (low) or “hi” (high) starts to
flash.
2. Switch with between low and high.
3. Confirm the setting with .
Low: 9600 bits/second
High: max 57 600 bits/second
Switching the sound on and off
WARNING
If you turn off the sound, the buzzer is effectively deactivated. You will have no audible warnings (alarms and
attentionmessages)!Withoutaudiblewarningyoucouldgetintopotentiallyhazardoussituations,whichcould
result in death or serious injury.
You must assume full responsibility for turning off the sound.