2-4
• The battery pack can be charged while the splicer is in use. Howev-
er, it takes longer hours (about 14 hours) compared with the time
when the splicer is powered off.
• Please charge the battery pack in the following temperature range.
The battery pack might be deteriorated (decrease in capacity) at the
temperature that exceeds this range.
*Temperature range for charging: 0°C~+40°C
CAUTION
Battery charging
Install the battery pack
The green LED illuminates
during charging.
<Keypad on the splicer>
Connect the AC adapter
1. Install the battery pack in the T-400S.
2. Connect the AC adapter to the T-400S.
3. A green LED on the key pad lights up when charging starts.
4. It takes about 4 hours to finish charging though it varies depending on
the remaining capacity. The green LED goes off when charging is
complete.
To Next Page
