3
<Handling of power cord and plug >
. Avoid places with too much dust or dirt. Dirt or dust that can accumulate in the fusion
splicer causes short circuit and insufficient cooling, which may lead to splicer
malfunction or deterioration, resulting in fire or electric shock.
21. Only use the battery pack, AC adapter and power supply cord for the splicer as
defined in this manual. Failure to do so can cause these items or the fusion splicer to
damage, resulting in fire or electric shock.
22. Only use a voltage within the indicated power voltage. Failure to do so can cause fire
or electric shock.
23. Check for condensation before operation. If this product gets wet with dew or the
like, leave it in a room temperature for about one day before turning it on. If water or
other liquid, a metallic object or other foreign substance gets inside the splicer,
immediately turn off the power and disconnect the power plug. Contact our qualified
service personnel.
24. In a high location, take safety measures to prevent fall of operators. Dropping the
splicer could result in personal injury. Fix the splicer to a worktable or a tripod with the
screw on the bottom of the splicer.
25.
If an abnormal condition such as unusual noise, smoke or unusual odor occurs,
imme
diately turn off the power and disconnect the power plug. Next, contact our
qualified service personnel.
26. Be sure to turn off the splicer and unplug the power cord or remove the battery pack
before replacing the electrodes.
27. Only use Sumitomo genuine electrodes (ER-10). And use the splicer with electrodes
installed in it. Failure to do so can cause the splicer to
damage, resulting in fire,
electric shock or malfunction.
28. If the heat shrink oven keeps running for a prolonged time, the surrounding parts
may become hot. Pay attention to the heat particularly in a high temperature
environment and use protective gloves as needed.
29. The supplied alcohol dispenser is not an airtight container. Pour alcohol into an
airtight container before transportation, so it does not spill out.
1. To reduce the risk of electric shock, do not plug/unplug the power cord or remove the
battery pack with wet hands.
2. Disconnect the power cord by grasping the plug, not the cord. Failure to do so can
cause damage to the power cord, resulting in fire, electric shock or malfunction.
3. Before charging the battery pack, make sure that the pins of the battery charge cord
are not bent or broken. Using the battery charge cord with a bent or broken pin can
cause internal short circuit, resulting in fire or electric shock.
4. In case AC power supply cord is damaged, replace with approved cord with
appropriate voltage and current rating.
To Next Page
Loading...
