4-11
Arc Pause
Stops the splicing process temporarily before arcing. If you
would like to check fiber offset and fiber end faces during the
process, set this function to ON.
Re-align After Arc
Fibers are aligned again prior to splicing after Arc Pause.
Auto Start
Automatically starts the splicing process when the fiber is in-
serted in the splicer and the hood is closed.
Heater Auto Start
Automatically starts the heating process when the fiber is
placed into the heat shrink oven.
Add Arc
Additional arc is available by setting this function to ON. If an
arc is insufficient, an additional arc should be performed.
Allows to adjust the arc power for additional arc.
To Next Page
Loading...
