x Netra 240 Server Service Manual • June 2004
FIGURE 3-5 Removing and Installing a Hard Drive 43
FIGURE 3-6 Removing a DVD Drive 46
FIGURE 3-7 Location of the DVD Drive Slot With a Filler Panel 48
FIGURE 3-8 Removing a Power Supply Unit 50
FIGURE 4-1 Removing the Alarm Board 55
FIGURE 4-2 Removing the Front Fan Assembly Tray 57
FIGURE 4-3 Removing the SCSI Interface Board 59
FIGURE 4-4 Lifting the SCSI/IDE Cable Clamp 62
FIGURE 4-5 Removing the SCSI Interface Board Cable and the IDE Cable From the System Board 63
FIGURE 4-6 Removing the System Configuration Card Reader Cluster 64
FIGURE 5-1 Removing/Rotating the Air Duct and Rear Fan Assembly 69
FIGURE 5-2 System Board CPUs and Corresponding Memory Locations 71
FIGURE 5-3 Removing and Inserting Memory 73
FIGURE 5-4 Location of the PCI Lockdown Screw 77
FIGURE 5-5 Location of the PCI Lockdown Bracket 78
FIGURE 5-6 Removing and Installing the Upper Half-Length PCI Cards 79
FIGURE 5-7 Removing and Installing the Lower Full-Length PCI Card 80
FIGURE 5-8 Removing the Power Distribution Board 82
FIGURE 5-9 Disengaging a Power Supply Unit 83
FIGURE 5-10 Removing and Installing the Hardware Cryptographic Module 86
FIGURE 5-11 Removing the PCI Riser Card Assembly 88
FIGURE 5-12 Disconnecting the PDB Wiring Harness From the System Board 89
FIGURE 5-13 Lifting the SCSI/IDE Cable Clamp 90
FIGURE 5-14 Removing the SCSI Interface Board Cable and the IDE Cable From the System Board 91
FIGURE 5-15 Detaching the Front Fan Assembly Cables From the System Board Connectors 92
FIGURE 5-16 Removing the DB-9 and SCSI Jackposts From the Server 93
FIGURE 5-17 Removing and Installing a System Board 94
FIGURE 5-18 Location of the CPU Heat Sink Assemblies 95
FIGURE 5-19 Detaching the Fan Power Cables 96
FIGURE 5-20 Unlocking the Heat Sink Fasteners 97
To Next Page
Loading...
