42 Netra 240 Server Service Manual • June 2004
4. Check that the device is now unconfigured:
5. Confirm that the hard drive you want to remove from the server is no longer
visible to the operating system:
6. Ensure that the server is properly grounded.
See “Avoiding Electrostatic Discharge” on page 32.
7. Grip the bezel at the two finger holds and rotate it down to open (FIGURE 3-1).
8. Check that the blue indicator LED is lit on the hard drive.
The blue LED comes on when the hard drive is ready to remove. See FIGURE 1-6 for
the location of the LED indicators for the hard drive.
9. Slide the catch at the front of the hard drive to the right (FIGURE 3-5).
# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 CD-ROM connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t0d0 disk connected configured unknown
c1::dsk/c1t1d0 unavailable connected unconfigured unknown
c2 scsi-bus connected unconfigured unknown
usb0/1 unknown empty unconfigured ok
usb0/2 unknown empty unconfigured ok
# format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
0. c1t0d0 <SUN72G cyl 14087 alt 2 hd 24 sec 424>
/pci@1c,600000/scsi@2/sd@0,0
Specify disk (enter its number):
To Next Page
Loading...
