4 Netra T2000 Server Administration Guide • September 2006
2. Ensure that the /etc/remote file on the Sun system contains an entry for
hardwire.
See
TABLE 1-2.
3. In a terminal window on the Sun system, type:
The Sun system responds by displaying:
The server and the Sun system are now communicating.
▼ To Access the System Console Through an Alphanumeric
Terminal
1. Attach one end of the serial cable to the alphanumeric terminal’s serial port.
Use a null modem serial cable, or an RJ-45 serial cable and null modem adapter.
Connect this cable to the terminal’s serial port connector.
2. Attach the opposite end of the serial cable to the serial management port on the
server.
3. Power on the alphanumeric terminal.
4. Set the alphanumeric terminal to receive:
■ 9600 baud
■ 8 bits
■ No parity
■ 1 stop bit
■ No handshake protocol
Refer to the documentation accompanying your terminal for information about how
to operate and configure the terminal.
TABLE 1-2 Entries for hardwire In the /etc/remote File
Serial port Entry for hardwire
ttya
hardwire:\
:dv=/dev/term/a:br#9600:el=^C^S^Q^U^D:ie=%$:oe=^D:
ttyb
hardwire:\
:dv=/dev/term/b:br#9600:el=^C^S^Q^U^D:ie=%$:oe=^D:
% tip hardwire
connected
To Next Page
Loading...
Need help?
General
