Chapter 4 Basic Administrative Tasks 51
3. Enable ASR. Type:
The system permanently stores the parameter changes and boots automatically.
▼ To Disable ASR
1. Obtain the ok prompt.
See “To Obtain the ok Prompt” on page 30.
2. Unconfigure diagnostic modes. Type:
3. Disable ASR. Type:
The system permanently stores the parameter changes and boots automatically.
Updating the Firmware
Updating or downgrading the firmware is accomplished using the flashupdate
command from the ALOM prompt. The flashupdate command updates the flash
PROMs in the system controller and the server motherboard. The flashupdate
command requires the network management port to be connected to a suitable
network. The network management port must be configured so that it can recognize
an external FTP server that contains the new firmware images to be downloaded.
To use the flashupdate command, you need to know the following:
■ IP address of the FTP server from which you want to download the firmware
image
■ Path at which the image is stored
■ Username and password to enter at the prompts
If you do not have this information, ask your network administrator.
ok reset-all
ok setenv diag-switch? false
ok reset-all
To Next Page
Loading...
Need help?
General
