Sun Microsystems Netra T2000 - To Switch between the System Console and ALOM; To Control the Locator LED; To Reset the Host Server; To View Environmental Information about the Server

Chapter 2 Advanced Lights Out Manager 21
▼ To Switch Between the System Console and
ALOM
● To switch from the console to the ALOM sc> prompt, type #. (hash-period).
● To switch from the sc> prompt to the console, type console.
▼ To Control the Locator LED
● To turn the LED on and off, use the setlocator command.
● To check the state of the LED, use the showlocator command.
The LED can also be controlled at the Solaris superuser prompt using the locator
command.
▼ To Reset the Host Server
1. Type the poweroff command.
This message is displayed:
2. Type the poweron command.
▼ To View Environmental Information About the
Server
ALOM can display system temperatures, hard drive status, power supply and fan
status, front panel LED status, rotary switch position, voltage and current sensors,
alarm status, and so on.
● To view environmental information, use the showenvironment command.
SC Alert: Host system has shut down.