34 Netra T2000 Server Administration Guide • September 2006
Stop-N Functionality
Stop-N functionality is not available. However, the Stop-N functionality can be
closely emulated by completing the following steps, provided the system console is
configured to be accessible using either the serial management port or the network
management port.
▼ To Restore OpenBoot Configuration Defaults
1. Log in to the ALOM.
See “Switching Between the Consoles” on page 6.
2. Type the following command:
Note – If you do not issue the poweroff and poweron commands, or the reset
command within 10 minutes, the host server ignores the bootmode command.
Issue the bootmode command without arguments to display the current setting.
3. To reset the system, type the following command:
sc> bootmode reset_nvram
sc> bootmode bootscript="setenv auto-boot? false"
sc>
sc> bootmode
Bootmode: reset_nvram
Expires WED SEP 09 09:52:01 UTC 2005
bootscript="setenv auto-boot? false"
sc> reset
Are you sure you want to reset the system [y/n]? y
sc>
To Next Page
Loading...
Need help?
General
