6 Netra T2000 Server Administration Guide • September 2006
5. After the system controller resets, use the shownetwork command to verify
network settings:
6. Exit the system controller session.
To connect through the network management port, use the telnet command to the
IP address you specified in Step 3 of “To Activate the Network Management Port”
on page 5.
Switching Between the Consoles
The system controller (SC) console connection provides access to the ALOM shell,
the Solaris OS, and the OpenBoot PROM.
This section describes the procedures to navigate between the following:
■ ALOM prompt (sc>)
■ Solaris OS prompt (#)
■ OpenBoot PROM prompt (ok)
These procedures are summarized in
FIGURE 1-1
sc> shownetwork
sc> console
To Next Page
Loading...
Need help?
General
