Sun Microsystems Netra T2000 - Stop-D Functionality; Stop-F Functionality

Chapter 3 OpenBoot PROM 35
4. To view console output as the system boots with default OpenBoot configuration
variables, switch to console mode.
5. Type set-defaults to discard any customized IDPROM values and to restore
the default settings for all OpenBoot configuration variables.
Stop-F Functionality
The Stop-F functionality is not available on systems with USB keyboards.
Stop-D Functionality
The Stop-D (Diags) key sequence is not supported on systems with USB keyboards.
However, the Stop-D functionality can be closely emulated by setting the virtual
keyswitch to diag, using the ALOM setkeyswitch command.
sc> console
ok