18 Netra T2000 Server Administration Guide • September 2006
Log Commands
The ALOM log commands display the console output and ALOM event buffers.
Status and Control Commands
The ALOM status and control commands enable you to perform typically manual
tasks with the server, remotely.
TABLE 2-4 ALOM Log Commands
Command Summary Example
consolehistory [-b
lines|-e lines] [-g lines]
[-v] [boot|run]
Displays the host server console output
buffers. The -v option displays the entire
contents of the specified log.
sc> consolehistory boot -b 10
showlogs [-b lines|-e
lines] [-g lines] [-v]
Displays the history of all events logged in
the ALOM event buffer.
sc> showlogs -b 100
TABLE 2-5
ALOM Status and Control Commands
Command Summary Example
bootmode [skip_diag |
diag | reset_nvram |
normal | bootscript=
"string"]
Controls the host server boot method through
the OpenBoot PROM firmware.
sc> bootmode reset_nvram
sc> reset
break [-y] [-c]
Drops the host server from the system into
OpenBoot PROM or kadb.
sc> break
clearasrdb
Removes all entries from the asr-db
blacklist.
sc> clearasrdb
clearfault UUID
Manually clears host-detected faults. UUID is
the unique fault ID of the fault to be cleared.
sc> clearfault 1234
console [-f]
Connects to the host system console. The -f
option forces the console write lock from one
user to another.
sc> console
disablecomponent asrkey
Adds a component to the asr-db blacklist,
where asrkey is the component to disable.
sc> disablecomponent
MB/CMP0/CH3/R1/D1
enablecomponent asrkey
Removes a component from the asr-db
blacklist, where asrkey is the component to
enable.
sc> enablecomponent
MB/CMP0/CH3/R1/D1
flashupdate [-s IPaddr -f
pathname] [-v]
Updates the ALOM firmware. This command
downloads main and bootmon firmware
images to ALOM.
sc> flashupdate -s 1.2.3.4 -f
/usr/platform/SUNW,Netra210/li
b/images/alommainfw
To Next Page
Loading...
Need help?
General
