Chapter 4 Basic Administrative Tasks 53
4. When prompted, type your username and password.
For example:
The username and password are based on your UNIX or LDAP user name and
password, and not your ALOM username and password.
After you type your username and password, the download process continues and a
series of periods appear across your screen.
For example:
When the download process is finished, ALOM displays the message:
5. Type the resetsc command to reset ALOM:
Note – To bypass the confirmation prompt, use the -y flag with the resetsc
command. If resetsc is issued from a Telnet session, upon reset the Telnet session
will be terminated. The output from the reset will be displayed through the serial
management port of the system controller.
The system controller resets, runs diagnostics, and returns to the login prompt.
Username: username
Password: password
................................................................
................................................................
.....................................
Update complete. Reset device to use new software.
SC Alert: SC firmware was reloaded
sc> resetsc
Are you sure you want to reset the SC [y/n]? y
User Requested SC Shutdown
To Next Page
Loading...
Need help?
General
