90 SPARC Enterprise Mx000 Servers Administration Guide • August 2009
▼ To Reserve Licenses for Allocation
You need to reserve licenses only if you want to make sure a specific number of
COD licenses are allocated to a particular domain.
1. Log in to the XSCF console with platadm privileges.
2. Type the setcod command.
You can use one of two methods, as follows.
■ Use setcod command with the -d domain_id and the license_quantity options:
For example:
■ Use the setcod command with no options.
This option allows you to reserve licenses for all domains at once. First, the
number of available licenses (8 in the example below) and the headroom
quantity prompt are displayed:
a. Enter a headroom number or press Return to leave the headroom unchanged.
The following prompts are displayed, in order:
b. Enter the number of licenses reserved for each domain.
The currently reserved number appears in parentheses. Do not exceed the
number of available licenses. To leave a reservation unchanged, press Return.
3. Verify the allocation with the showcod command.
XSCF> setcod -d domain_id license_quantity
XSCF> setcod -d 1 4
XSCF> setcod
COD
---
PROC RTUs installed: 8
PROC Headroom Quantity (0 to disable, 4 MAX) [0]:
PROC RTUs reserved for domain 0 (6 MAX) [0]:
PROC RTUs reserved for domain 1 (6 MAX) [2]:
PROC RTUs reserved for domain 2 (4 MAX) [0]:
PROC RTUs reserved for domain 3 (4 MAX) [0]:
To Next Page
Loading...
Need help?
General
