Chapter 4 Domain Configuration 65
Backup and Restore Operations
For domain backup and restore operations, see your backup software documentation
for instructions. The Solaris OS documentation collection also contains information
on backup and restore operations.
Dynamic Reconfiguration
Dynamic reconfiguration allows you to add PSBs to or remove them from midrange
or high-end server domains without stopping the Solaris OS. DR is not supported on
entry-level servers. You can use dynamic reconfiguration to redistribute your
midrange or high-end server resources by adding or removing system boards as
needed or to replace failed system boards with new ones. For more information, see
the SPARC Enterprise M4000/M5000/M8000/M9000 Servers Dynamic Reconfiguration
(DR) User’s Guide and the Service Manual for your server.
XSCF Shell Procedures for Domain
Configuration
This section describes these tasks:
■ To Set CPU Operational Mode
■ To Specify XSB Mode on a Midrange or High-End Server
■ To Set Up a Domain Component List for a Midrange or High-End Server Domain
■ To Assign an XSB to a Midrange or High-End Server Domain
■ To Power On a Domain
■ To Display System Board Status
■ To Access a Domain From the XSCF Console
■ To Attach a CD-RW/DVD-RW Drive or Tape Drive While the Solaris OS Is
Running on a High-End Server
■ To Disconnect a CD-RW/DVD-RW Drive or Tape Drive While the Solaris OS Is
Running on a High-End Server
Note – To change configuration of a domain, the target domain must be powered
off.
To Next Page
Loading...
Need help?
General
