Chapter 4 Domain Configuration 69
3. Type the cfgdevice command:
a. To check the status of current drives:
b. To attach a drive:
where port_no is the port number in the specified domain where the device is to
be attached. port_no is specified in the format: IOU number-PCI slot number.
4. Mount the drive by typing the cfgadm command:
where Ap_Id is the attachment point of the controller, for example, c0.
5. Restart the volume management daemon (vold) if necessary:
▼ To Disconnect a CD-RW/DVD-RW Drive or
Tape Drive While the Solaris OS Is Running on a
High-End Server
1. If the volume management daemon (vold) is running, stop the daemon:
2. Detach the drive by typing the cfgadm command:
where Ap_Id is the attachment point of the controller. For example, if the drive is
connected to controller c0, you would type:
3. Log in to the XSCF console with platadm privileges.
XSCF> cfgdevice -l
XSCF> cfgdevice -c attach -p port_no
# cfgadm -c configure Ap_Id
# /etc/init.d/volmgt start
# /etc/init.d/volmgt stop
# cfgadm -c unconfigure Ap_Id
# cfgadm -c unconfigure c0::dsk/c0t4d0
# cfgadm -c unconfigure c0::rmt/0
To Next Page
Loading...
Need help?
General
